Extension Table for Grizzly Tablesaw I made a frame of 1x2 poplar from the sawmill. I pocket screwed the boards together. I covered the frame with 5/8 plywood. On the exposed sides I banded it with some oak, and glued some Formica on top. I polyurethane all the exposed wood and used 6 brass thread inserts to attach the table to the rails. Cabinet under right wing of Grizzly Tablesaw I have started a cabinet under the extension table on the tablesaw. I will have enough storage for all my tablesaw accessories and extra room left over. There will be a total of 7 drawers. Here are all the pieces for the drawer sides, and then the drawers completed. The carcass and drawers have been polyurethaned and I have started installing the drawers. I have to make the drawer fronts next. The drawer fronts are complete and poly'd. The drawers are going in, and complete.   Bathroom Vanity I have started a vanity for in my bathroom. This the pieces cut out for the face frame. I pocket screwed the face frame together. I made a raised panel assembly for the right side of the cabinet. I glued a plywood bottom and left side to the cabinet. I am cutting the dovetails for the drawers. I have 5 drawers assembled. I have the doors and drawer fronts made. I test fit the vanity top.